Installation manual

Step 12: Pull the LED PCB from the enclosure and disconnect the connector on the back of the PCB.
Step 13: Remove the grommet and other side of the harnessing from the plastic harness (there are 2
ways to do this):
A) If you plan on reinstalling this tail light again in the future, do not cut the connector off!
Using needle-nose pliers, press in the tabs on each pin and pull it out of the connector block. This way
the grommet and wires can come out through the enclosure opening while the connector block is
removed from the other side.
B) If you do NOT plan on reinstalling this tail light again, simply cut the connector block off and
pull out the wires and grommet. (The wires can always be re-installed later through soldering or crimp
connectors if needed).