Service manual

OIL PUMP
5-63
NOTE:
When installing the inner rotor, align the pin “1”
in the oil pump shaft with the groove in the
inner rotor “2”.
3. Install:
• Oil/water pump driven sprocket “1”
NOTE:
5VY mark of the oil/water pump driven gear is
installed at oil pump side.
4. Check:
• Oil pump operation
Refer to "CHECKING THE OIL PUMP" on
page 5-61.
EAS25030
INSTALLING THE OIL/WATER PUMP
ASSEMBLY
1. Install:
• Oil ring
• Oil/water pump assembly “1”
•Dowel pin
• Bolts “2”
2. Install:
• Washer
• Oil/water pump assembly drive chain “1”
• Oil/water pump assembly drive sprocket “2”
•Collar
NOTE:
Install the oil/water pump assembly drive chain
“1” onto the oil/water pump assembly drive
sprocket “2”.
CAUTION:
EC2D1008
After installing the oil/water pump assem-
bly drive chain and drive sprocket, make
sure the oil/water pump turns smoothly.
3. Install:
• Oil/water pump assembly drive chain guide
“1”
NOTE:
“UP” mark of the oil/water pump assembly
drive chain guide is upward.
Oil/water pump driven sprocket
bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
LOCTITE®
Oil/water pump assembly bolt
12 Nm (1.2 m·kg, 8.7 ft·lb)
LOCTITE®
Oil/water pump assembly drive
chain guide bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
LOCTITE®