Service manual

AIR INDUCTION SYSTEM
7-15
Out of specification → Replace the reed
valve.
4. Check:
• Air cut-off valve
Cracks/damage → Replace.
5. Check
• Air induction system solenoid
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the air induction system solenoid
coupler from the wire harness.
b. Connect the pocket tester (Ω × 1) to the air
induction system solenoid terminals as
shown.
c. Measure the air induction system solenoid
resistance.
d. Out of specification → Replace.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS27070
INSTALLING THE AIR INDUCTION SYSTEM
1. Install:
Plate
Reed valve assembly
Reed valve cap
2. Install:
Air cut-off valve
Air cut-off valve hose 1
Air cut-off valve hose 2
Air cut-off valve hose 3
Air cut-off valve coupler
Reed valve bending limit
0.4 mm (0.016 in)
• Positive tester probe
Brown terminal “1”
• Negative tester probe
Brown/Red terminal “2”
Air induction system solenoid
resistance
18–22Ω at 20°C (68°F)