Service manual

FUEL INJECTION SYSTEM
8-45
Sensor operation table
Diag-
nostic
code
No.
Item Meter display Checking method
01
Throttle position sensor sig-
nal
• Fully closed position 15–18 Check with throttle valve
fully closed.
• Fully opened position 95–100 Check with throttle valve
fully opened.
02
Atmospheric pressure Displays the atmospheric
pressure.
Compare the actually mea-
sured atmospheric pres-
sure with the meter display
value.
03
Intake air pressure Displays the cylinder-#1
intake air pressure.
Set the engine stop switch
to “ ” then operate the
throttle while pushing the
start switch “ ”. (If the dis-
play value changes, the
performance is OK.)
05
Intake air temperature Displays the intake air tem-
perature.
Compare the actually mea-
sured air temperature with
the meter display value.
06
Coolant temperature Displays the coolant tempera-
ture.
Compare the actually mea-
sured coolant temperature
with the meter diaplay
value.
07
Vehicle speed pulse 0–999 Check that the number
increases when the rear
wheel is rotated. The num-
ber is cumulative and does
not reset each time the
wheel is stopped.
08
Lean angle sensor Remove the lean angle
sensor and incline it more
than 65 degrees.
• Upright 0.4–1.4
• Overturned 3.7–4.4
09
Fuel system voltage
(battery voltage)
Approximately 12.0 Set the engine stop switch
to “ ” and then compare
with the actually measured
battery voltage. (If the bat-
tery voltage is lower,
recharge the battery.)
20
Sidestand switch Set ON/OFF the sidestand
switch (with the transmis-
sion in gear).
• Stand retracted ON
• Stand extended OFF
21
Neutral switch Set ON/OFF the neutral
switch (shift the transmis-
sion).
• Neutral ON
• In gear OFF