User Manual
Genos Owner’s Manual 21
Panel Controls and Terminals
XLR jack connected to the MIC INPUT jack. Only turn
this switch on/off after connecting a phantom powered
condenser microphone to the device. Always turn the
phantom power switch to OFF when it is not required.
$1 AC IN jack ........................................................ Page23
For connecting the supplied power cord.
$2 [TO LEFT SPEAKER] jack ......................... Page118
For connecting an optional set of speakers.
$3 [USB TO DEVICE] terminal
(underneath the instrument)..................Pages21, 111
For connecting a USB flash drive. For information
about opening/closing the cover, see below.
When using phantom power, observe the following to prevent
noise and possible damage to Genos or connected equipment.
• Do not connect or disconnect any devices while the phantom
power switch is ON.
• Set all output level controls to the minimum before turning
the phantom power switch to ON or OFF.
• When connecting a device not requiring phantom power to
the MIC INPUT jack, make sure to turn the phantom power
switch to OFF.
NOTICE
When the phantom power switch is turned on and off, the input from MIC
INPUT jack will be muted a few seconds.
NOTE
Using the USB TO DEVICE terminal underneath the instrument
Genos has a convenient extra USB TO DEVICE terminal underneath the instrument, allowing you to semi-perma-
nently install USB flash drive that will always be available and be protected from harm or loss.
Before following the steps below, make sure you have a Philips screwdriver. Also, before using a USB flash drive,
refer to “Connecting USB Devices” on page 111.
1 Remove the screw from cover.
2 Open the cover.
The USB TO DEVICE terminal appears.
3 Connect the USB flash drive.
4 Close the cover, and tighten the screw removed
in Step 1.
Front
Rear Cover
Keep the removed screw in a safe space. It will be used when closing
the cover.
NOTE
#6
#7
#8
#9
$0
$1
$2
@9 @9