User Guide

Compatible operating systems

The GO46 can only be used under Mac OS 10.3.6 (OS X) or higher.

Refer to the system requirements printed on the package, or in the PDF manual page 25. You can

also check the latest system requirements on the Internet.

http://www.yamahasynth.com/

Installing the Control Panel

The GO46 uses the operating system’s CoreAudio and CoreMIDI drivers. Therefore, it is not

necessary to install a device-specific driver. Simply plug the device into your IEEE1394 (FireWire)

port using the included cable and the GO46 can be used immediately. However, to take full

advantage of the advanced routing, sample rate switching, and other control features, please

install the included Control Panel.

Insert the included “TOOLS for GO44/GO46” CD-ROM in the CD-ROM drive of

your computer.

Double-click on the CD-ROM drive icon and open

[GO46Driver_] → [GO46

Setup.pkg] to start the InstallShield Wizard.

3. The welcome message of the InstallShield Wizard appears. Click [Continue].

4. Select the hard disk drive where the Mac OS is installed as the destination for the

installation. Click [Continue].

5. Click [Install] to start the installation.

6. Click [Restart] to complete the installation.

For information about the Control Panel, see page 20 of the PDF manual.

Assigning the GO46 as the default system audio

device (Mac OS X)

If you would like to use the GO46 not only for specific audio applications, but as your default

Mac OS X audio device, select the GO46 audio driver in the [Sound] control panel as the default

device for audio output.

Software Installation — Macintosh

users

NOTE