Service manual
4-31
FUEL
E
OIL PUMP
2. Adjust:
● Oil pump cable
Adjustment steps:
● Loosen the locknut 1 and the adjust-
ing nut 2.
● Fully close the carburetor throttle
valves.
● Adjust the oil pump cable so that the
mark a on the oil pump lever is
aligned with the mark b on the oil
pump body.
● Tighten the adjusting nut and locknut.
1
2
Oil injection pump air bleeding
1. Bleed:
● Air
Air bleeding steps:
● Place rags around the air bleed screw
1 to catch any oil that might spill.
● Fill the oil tank with the recommended
oil.
NOTE:
If the oil pump is replaced or the oil suc-
tion hose is removed, bleed air from the
oil suction hose by removing it from the
oil pump.
After bleeding the air, reconnect the
hose with a locking tie.
Recommended engine oil:
YAMALUBE 2-W or an
equivalent TC-W3 certified
outboard oil
● Loosen the air bleed screw 1 two full
turns and make sure that both the oil
and air bubbles flow out.
● When there are no air bubbles left,
tighten the air bleed screw.
● Wipe up any spilt oil.
1