User Manual

DTX900

TIPS!

This section provides tips on how to make your drum triggers even easier to use.

 Configuring Startup Settings

You can configure settings so that stored pad type and voice settings will be automatically selected when you turn on the

drum trigger module.

1. Press the [UTILITY] button to access Utility mode.

2. Press the [F1] GENERAL button, and then the [SF4] STARTUP button to call up the display for making the drum trig-

ger module’s startup settings.

3. Select a User Kit (q, w) that you stored as described in “2-4. Storing Drum Voices”.

4. Select a User Trigger Setup (e) that you stored as described in “2-2. Storing Pad Types”.

5. Press the [ENTER/STORE] button to store your settings.

qew

Notice

Never attempt to turn off the drum trigger module while the message “Utility stored.” is shown. If this precaution is not

observed, user data may be lost or the internal system may be damaged, rendering your drum trigger module unable to

startup normally when it is next turned on.