User Manual

16

Installing a cartridge
Acartridgeisnotincludedwiththisproduct.Followthe
stepsbelowtoinstallacommercially-availablecartridge
into the head shell.
Note
Refer to the instruction manual for the cartridge.
1
Connect the lead wires to the cartridge.
Lead wire Connector
Red
Æ
R+ (red)
Green
Æ
R– (green)
White
Æ
L+ (white)
Blue
Æ
L– (blue)
2
Provisionally secure the cartridge to
the head shell.
3
Adjust the position of the cartridge.
Adjustthepositionofthecartridgeandstylusas
shown in the following illustration.
52 mm
Note
Theoverhangofthetonearmonthisunitis
−17mm.
4
Firmly secure the cartridge.
Verify that the side of the head shell is parallel
withthecartridge,andthenrmlytightenthe
screws.
5
Attach the head shell to the tonearm.
Insert the head shell into the front end of the
tonearm,andturnthelocknuttosecureit.
Note
If you prefer, attach the washer to the head shell.
Washer