User Manual

15
1
Install the sub platter onto the center
spindle.
NOTICE
Do not apply force to the center spindle when
you install the sub platter onto the center
spindle. Otherwise, the center spindle might
be damaged.
2
Install the belt around the sub platter
and pulley.
Makesurethatthebeltisnottwisted.
Rotatethesubplatterclockwisetoensurethatthe
belt will be well seated.
3
Screw the handles into the platter,
and then lift the platter by holding the
handles.
CAUTION
Takecarenottodroptheplatter.Droppingit
mightcauseinjury,ordamagetheunit.
4
Install the platter onto the center
spindle.
Removethehandlesfromtheplatter.
5
Place the turntable mat on the platter.
Note
• You can use the rubber or felt turntable mat.
• The side of the rubber turntable mat with a dent
in the center should face upward.
6
Attach the dial cover to the PITCH
ADJUST.
7
Attach the counter weight to the
tonearm.
Withthemarkingsonthecounterweightfacing
you,slideitontothebackendofthetonearm.
Note
Depending on the weight of the cartridge, install
thelargeorsmallcounterweight.Forinformation
about acceptable cartridge weights for each
counterweight,refertothe“Specications”
section on page 28.