User Manual
Table Of Contents
19
Power Connection
Connect the supplied power cord to the rear panel
ACINconnector,thenconnecttheotherendtoan
AC outlet.
CAUTION
For safe operation, always connect the ground
wire.
AC IN Connector
Power Cord (supplied)
Rear Panel
Using the Effect Loop
UsetheEFFECTLOOPSEND/RETURNjacksto
connect an external effector.
(Diagram 1)
YoucanswitchtheEffectLoopON/OFFusingthe
includedfootswitch.(→page20)
* The external effects circuit is set to parallel at
factory but can be switched to serial using the
“THR HD_H Utility” application. (→ page 21)
OntheTHR100HD,theSEND/RETURNjacksare
stereo(TRS),withAmpIassignedtotheTipand
AmpIIassignedtotheRing.(Diagram 2)
To connect an external effect to Amp I only, use a
monaural phone cable.
To connect external effects to Amp I and Amp II
separately,useaninsertcable(stereo→monox2)
as shown in the diagram below. (Diagram 3)
IN OUT
Diagram 1 Diagram 2 Diagram 3
Effector
Amp I Effector Amp II Effector
Tipe (L): Amp I
Ring (R): Amp II
Sleeve (G): GND
Monaural Phone Jack
Left
Side
Right
Side
L RL R