User Manual
Table Of Contents
23
Troubleshooting
No power
l
Is the power cord properly connected?
(→page19)
No sound
l
Is an instrument properly connected to the
INPUTjack?
l
THR100HD: Is the instrument connected to
theINPUTIIjack?Ifonlyasingleinstrument
is being used, it must be connected to the
INPUTIjack.
l
Istheinstrument’svolumecontrolturnedup?
l
AretheGAIN,MASTER,orVOLUMEcontrols
set to “0”?
l
Is the Amp Select switch properly set?
l
Is the cabinet properly connected? (→ page
16)
l
IfyouhaveselectedtheCLEANamptype,no
sound is produced if the tone controls are set
to “0”.
l
Are a pair of headphones connected to the
PHONESjack?
l
Is the cable used to connect the instrument to
the amp damaged?
l
Is the cable used to connect the amp to the
cabinet damaged?
l
IstheEffectLoopmodesettoaserial
connectionwiththe“THRHD_HUtility”?
In the serial connection mode, no sound is
produced if the loop is active without an effect
connectedtotheEFFECTLOOPSEND/
RETURNjacks.(→ page 21)
Stopped producing sound while
playing
1) The front grill lamp is not lit
l
The thermal protection system has activated,
terminatingoutputtotheSPEAKEROUTjack.
Allowtheampliertocooldownthenswitch
thepowerONagain.Ifthethermalprotection
system activates again, unplug the power cord
and contact the Yamaha dealer from whom
you purchased the device.
l
The tip end of the speaker cable is grounded
or touched by static electricity causing a short.
Check the speaker cable and after eliminating
thecause,switchthepowerOFFandthenON
again. If the protection circuit activates again,
immediatelyturnthepowerOFF,disconnect
the power cord, and contact the Yamaha
dealer from whom you purchased the device.
2) The power is OFF
l
The internal circuitry may not be functioning
properly.ImmediatelyturnthepowerOFF,
disconnect the power cord, and contact the
Yamaha dealer from whom you purchased the
device.