Operation Manual
E-34
• When recording important selections, be sure to make a
preliminary test to ensure that the desired source material
is being properly recorded with good sound quality.
• The automatic recording level control circuit automatically
controls the level of the input signal used for recording.
• Adjusting the VOLUME control and using the built-in
sound field processor have no effect on the recorded
sound.
If, however, the built-in graphic equalizer is used, its effect
is recorded along with the source.
* Music with an equalizer effect is suitable for listening to
inside a car etc.
• For the tape deck, the deck which can be used for
recording is the deck 2 only. When recording, be sure to
load a tape into the deck 2 cassette compartment.
Recording from the built-in tuner
1 Press the TUNER input selector button.
2 Tune to the desired station. (Refer to the “TUNING
OPERATION” on page 17 and 18.)
3 Load a tape into the deck 2 cassette compartment.
4 When recording with the Dolby NR system, press the
DOLBY NR button so that “ B” lights up on the display.
If not, turn it off.
* For details, refer to the “Dolby B Type Noise
Reduction” on page 24.
5 Select the reverse mode “ ” to record on only one
side, or “ ” for continuous recording on both sides by
pressing the reverse MODE selector button.
6 Press the REC/PAUSE button.
* “REC” lights up on the display.
7 Press the play button on the remote control transmitter
to record on side A, or the play button to record on
side B.
* For continuous recording on both sides, begin on side
A. Recording stops automatically at the end of side B.
To stop recording temporarily
11 Press the REC/PAUSE button.
22 To resume recording, press the play button.
To stop recording
Press the stop button.
To reduce beats during recording
While recording an AM (long wave) broadcast, you may hear
a bleep caused by beat frequencies. In such a case, pressing
the TUNER input selector button once or more will reduce or
remove beats. (Whenever the TUNER input selector button is
pressed, “B.C–1” and “B.C–2” appears on the display
alternately. Select either of them in which you find that beats
are more reduced.)
OTHER RECORDINGS
1
PLAYBACK
2
REC/PLAYBACK
EJECT
OPEN/CLOSE
DISC CHANGE
Active Servo
Technology
MINI COMPONENT SYSTEM
GX
–
50
1
2
3
DISC
LOCATION
USER
VOLUME
DOWN UP
MEMORY
BAND
REC/PAUSE
MODE
HOUR MIN
NORMAL
DUBBING
HIGH
MEMORY
TIME ADJ
DOLBY NR
AUTO/MAN’L
TIMER
TIMER REC
MUSIC
POWER
PHONES
PRESET/TUNING
A/B/C/D/E
RANDOM
REPEAT
EDIT
DISPLAY
CD
TUNER AUX
TAPE 1/2
START
MODE
FREQ PS/PTY/RT/CT
PTY SEEK
EJECT
4 5 6, 11 3
1
1
2
2
3
3
4
4
5
5
TIME
A
DISC SKIP
PROG
B
TAPE
C
EDIT
D
+I0
E
OPEN
/
CLOSERANDOM
REPEATMODE
6
6
7
7
8
8
9 0
CD
PRESET
TUNER
TAPE
STOP
STOP
PLAY
/
PAUSE
PLAYPLAY
LOCATION
USER FLAT
MUSIC
REC
/
PAUSE
DECK 1
/
2
POWER
INPUTSLEEP
VOLUME
1
6, 11
7, 22
1