User Manual

Revolabs HD Venue™ Base Station Audio

Connections

There are two balanced inputs (either ¼” or XLR) and two balanced outputs

(either ¼” or XLR) on the back panel of the unit providing access to each

channel’s audio signal.

¼” jacks are configured as follows:

Tip

positive

Ring

negative

Sleeve

ground

XLR connectors are configured as follows:

Pin 1

ground

Pin 2

positive

Pin 3

negative

There are two output channels representing a separate channel for each

microphone. The microphone output connectors need to be attached to the

input connectors of an audio mixer.

The Base Station input connectors (also 0 dBu) may then be attached to mixer

channel outputs. Because the system is full-duplex, the input connections

provide the ability to hear program audio using a 2.5mm earpiece attached to

the microphone (supplied with the wearable microphone). Depending on the

application, it is possible to feed a single audio feed back to each earpiece. This

would allow for translation, personal hearing assistance or other services to be

incorporated into an application.

NOTE: The USB port may exhibit static sensitivity. If the Base Station audio

shuts down after handling, please power cycle the Base Station

Note: The HD Venue System is not compatible with any other Revolabs system and

therefore cannot be installed in the same room. The HD and Solo Wireless

Microphones and Charger Bases are not interchangeable. Only two HD Venue

Systems can be used in a single area. Please contact

https://uc.yamaha.com/

resources/support/

for design recommendations.