User Manual

14
Configuring the Revolabs HD Venue
TM
Base Station
Each Revolabs HD Venue Base Station must be configured properly prior to
use. Accurate configuration is dependent on several variables such as:
• Is Line Level or Mic Level signal required?
Refer to setting Dip Switch 3 below.
• How many HD Venue Systems are being used together in close
proximity?
If you have more than one Revolabs HD Venue Wireless
Microphone System, refer to setting Dip Switches 5 and 6 below.
Note: It is recommended that the lowest functioning Transmit Power
be used for each system.
• How large is the room?
Refer to setting Dip Switches 7 and 8 below. Note: It is
recommended that the lowest functioning Transmit Power be used
for each system.
Using the Rear Panel Configuration DIP Switches
DIP
Switch
Feature Off (Default) On
1
Output
Mixing
Individual
Outputs
Mixed Output
2
Low Pass
Filter
No LPF LPF
3
Audio Output
Level
Line Level Mic Level
4
Mute Mode
Individual Mutes
No Mutes
5
Sharing
Mode
All frequencies
will be used
Half of the
frequencies will be
used
300’ 150’ 75’ 25’
7
Transmit
Off
On
Off
On
8
Power
Off
Off
On
On
6
A/B Freq
Groups
A Frequencies B Frequencies
Changes in DIP switch configurations require a power cycle (off/on) to take
effect.