User Manual

15
Configuration Settings
DIP Switch 1 – Output Mixing:
When DIP Switch 1 is OFF (default), each HD microphone has its own balanced
audio output on the Base Station. When DIP Switch 1 is switched on, the audio
outputs of the two HD microphones are mixed together and sent to both
outputs.
DIP Switch 2 – Low Pass Filter:
When DIP switch 2 is OFF(default) the microphone provides the full audio
bandwidth. When DIP switch 2 is ON, a LPF is activated reducing the audio
bandwidth.
DIP Switch 3 – Audio Output Level:
When DIP switch 3 is OFF(default) the microphone outputs provide a line level
signal~0 dBu. When DIP switch 3 is ON, the microphone outputs provide a mic
level signal ~-40 dBu.
DIP Switch 4 – Mute Mode:
When DIP switch 4 is OFF(default) each microphone has its own individual
muting capabilities. When DIP switch 4 is ON, the microphone mute buttons
are deactivated resulting in the mics always being active and un-muted when
not in the Charger Base.
DIP Switch 5&6 – Sharing Mode:
To use two HD Venue Systems in the same area, both systems must have DIP
Switch 5 set to ON. One of the HD Venue Systems must have DIP Switch 6 set
to ON (A frequencies) and the other HD Venue System must have DIP Switch 6
set to OFF (B frequencies).
DIP Switch 7&8 – Transmit Power:
The transmit power of the Base Station can be adjusted to help reduce the
operational radius of a Revolabs HD Venue System in order to prevent
interference from other Revolabs products, or from other devices operating in
the same frequency.
Note: It is recommended that the lowest functioning Transmit Power be used for
each system.