User Manual

To use the HD Omni Tabletop Microphone:

1. Remove the microphone from the Charger Base to turn on and

automatically mute the mic. (indicated by a flashing RED LED)

2. Omni Tabletop microphones can be centered on the table within 2 to 6 feet

(0.6 to 2m) away from people speaking and do not need to be pointing any

particular direction because they pick up sound from all directions. It is

always better to be as close to the person speaking as possible, but avoid

placing the microphone where it might be blocked by equipment or

paperwork. Avoid placing microphones too close to an audio or video

conference speaker to avoid echoes. Make sure that the microphone is

always placed lying on its rubber feet atop a flat surface.

3. With the microphone in position on the table, un-mute the microphone by

pressing and releasing the Mute button (confirm by a flashing GREEN LED).

4. To turn microphone off, return the microphone unit to the Charger Base or

press and hold the Mute button for ~10 seconds until the LED turns solid

RED and release button.

If the microphones are placed too far from the Base Station (~300 feet or 90

meters) the connection will be dropped (LED flashes all colors) and the

microphone will mute. After 15 seconds the microphone will beep 5 times, and

will continue beeping every 30 seconds to indicating it’s out of range.

Move the microphone closer to the Base Station and the connection will

automatically be re-established to its original state, and the beeping will cease.

If not, the microphone will continue beeping until it turns off in about 15

minutes.