User Manual

To use the HD Directional Tabletop Microphone:

1. Remove the microphone from the Charger Base to turn on and

automatically mute the mic. (indicated by a flashing RED LED)

2. Directional Tabletop microphones should be located on the table with the

acoustic cover pointed toward the users, trying to keep the microphone 2 to

6 feet (.6 to 2m) from the target person or two. The pick-up pattern for this

directional microphone is ~+/- 45º to either side of directly in front of the

microphone. It is always better to be as close to the person speaking as

possible, but avoid placing the microphone where it might be blocked by

equipment or paperwork. Avoid placing microphones too close to an audio

or video conference speaker to avoid echoes. Make sure that the microphone

is always placed lying on its rubber feet atop a flat surface. Refer to

diagram below:

3. With the microphone in position, un-mute the microphone by pressing and

releasing the Mute button (confirm by a flashing GREEN LED).

4. To turn microphone off, return the microphone unit to the Charger Base or

press and hold the Mute button for ~10 seconds until the LED turns solid

RED and release button.

If the microphones are placed too far from the Base Station (~300 feet or 90

meters) the connection will be dropped (LED flashes all colors) and the

microphone will mute. After 15 seconds the microphone will beep 5 times, and

will continue beeping every 30 seconds to indicating it’s out of range.

Move the microphone closer to the Base Station and the connection will

automatically be re-established to its original state, and the beeping will cease.

If not, the microphone will continue beeping until it turns off in about 15

minutes.