User Manual

29
1
2
3
Revolabs HD Venue
TM
Charger Base
When microphones are not in use, they should be properly inserted into the
Revolabs HD Charger Base. It is important to ensure that all system
microphones are inserted fully in the base so that charging will occur. Features
of the base are shown in the following figure.
1.
LED indicator — power status indicator
2. Charger Bays — charges up to 2 Microphones
3. Power Cord Receptacle — power supply input, 9–24VDC (on rear)
Power Module
The Charger Base requires 5VDC power, provided by the AC Adapter. Plug the
supplied AC adapter into an appropriate power outlet 110–240 AC, 50–60Hz.
The power LED on the Charger Base will illuminate.
Charging the Microphone Batteries
First-time use — Before using the wireless microphone the first time, charge
the batteries in the microphones for eight hours (or overnight) in the Charger
Base.
Recharging — When the YELLOW LED starts to flash intermittently on the
microphone the battery has 30 minutes of charge remaining. Over time (years),
batteries gradually wear down and will result in shorter run times. This is
normal. Always return microphones to the Charger Base when not in use.
Important: The Lithium Polymer rechargeable batteries that power the
microphones were released with both replaceable and non-replaceable type
batteries. To distinguish between the 2 different type versions is by serial
number only. Serial numbers are located on the label of the back of the
microphone itself. Any serial number preference starting with either 7010 or
8020 are equipped with current replaceable rechargeable Lithium Polymer type
batteries. If the serial number preference is anything else but 7010 or 8020
Please contact Yamaha ( https://uc.yamaha.com ) or your AV service provider for