User Manual

30
replacement instructions for returning and servicing non replaceable type
microphone batteries. For replaceable type battery microphones, with serial
number preference starting with either 7010 or 8020, replace only with the same
manufacturer and model battery type recommended by Revolabs. Please
contact Yamaha UC o r your AV service provider for correct manufacturer
approved and recommended replacement type batteries or process for return and
replacement for either type battery.
Caution: Risk of explosion if batteries are mishandled or replaced by an incorrect
type. Do not disassemble batteries or attempt to charge outside the system. Do not
dispose of batteries in fire. Dispose of batteries in accordance with manufacturer’s
instructions and local regulations.
Either a solid RED LED (charging) or solid GREEN LED (100% charged) will
appear to confirm that the microphone is inserted properly in the Charger
Base. The microphones are not transmitting audio to the HD Base Station
while in the Charger Base. In normal use, batteries should fully charge in
about 2 hours, but will “quick-charge” to 80% capacity in approximately 1 hour
and 20 minutes. Fully charged microphones left in the Charger Base remain
solid GREEN.
Updating the Revolabs HD
TM
Firmware
Revolabs HD
TM
Systems are field upgradable for the firmware portion of the
Base Station and microphones. The firmware must be sent to the Base station
using the Revolabs HD Panel. The software can be downloaded at
https://uc.yamaha.com/resources/support/.
Updating the HD Venue Base Station and HD Microphones
1. Connect to the Base Station using the mini-USB cable.
2. Pair both mics to the Base Station and make sure they are out of the
Charger Base.
3. Start the Revolabs HD Control Panel software
4. Select the “Firmware” button on the Control Panel
5. Choose the desired firmware version from the location it was saved
during download.
6. Choose whether you would like to update the Base Station, Mics, or
Both.
7. Select OK. The Revolabs HD Firmware Loader will notify you when
complete.
The HD Microphone firmware updates wirelessly during the firmware process
as long as the microphones are out of the Charger Base, paired to the Base
Station, and communicating with the Base Station.