User Manual

Configuring the system settings (ADVANCED SETUP menu)
43 En
English
ADVANCED
OPERATION
Configure the system settings of the unit while viewing the front display. The ADVANCED SETUP menu can be
operated from the front panel.
1 Press
A
(power) to turn off the unit.
2 While holding down RETURN on the front
panel, press
A
(power).
3 Rotate SELECT/ENTER to select an item.
4 Press SELECT/ENTER to select a setting.
5 Press
A
(power) to set the unit to turn off and
turn it on again.
The new settings take effect.
ADVANCED SETUP menu items
* Only for Asia and General models
Checking the firmware version
(VERSION)
Check the version of firmware currently installed on the
unit.
Note
• You can also check the firmware version in “Update (Network
Update)” (p. 41) in the “SETUP” menu.
• It may take a while until the firmware version is displayed.
Selecting the remote control ID
(REMOTE ID)
This changes the remote control ID on the unit.
Normally, this should be set to “ID1”. When operating the
unit using remote controllers included with certain
Yamaha players, set this to “AUTO”.
Settings
ID1 (default), AUTO
Setting tuner frequency step (TU)
Selects the step size for locating tuner frequencies.
(Only for Asia and General models)
Settings
FM100/AM10, FM50/AM9 (default)
Restoring the default settings (INIT)
Restores the default settings for the unit.
Choices
Configuring the system settings (ADVANCED SETUP menu)
Item Function Page
VERSION
Checks the version of firmware
currently installed on the unit.
43
REMOTE ID Selects the unit’s remote control ID. 43
TU
*
Sets tuner frequency step. 43
INIT Restores the default settings. 43
UPDATE Updates the firmware. 44
SPEAKERSPHONES
VOLUME
SELECT
RETURN
PUSH ENTER
CONNECT
DISPLAY MODE MEMORY BAND PRESET TUNING
BASS TREBLE INPUT
DISPLAY SELECT/ENTERA
RETURN
(power)
CANCEL
(default)
Does not perform an initialization.
NETWORK
Initializes all of the network and Bluetooth
settings. If you initialize the unit, all presets for
the network input sources (p. 36) will be cleared.
ALL Restores the default settings for the unit.