User Manual

6 Place one of the felt pads removed in Step 2 on the cymbal holder. (See Figure 5.)

7 Mount the pad unit on the cymbal stand. Lower the pad unit into place with the cymbal holder’s

shaft passing through the central hole of the Cup section. When mounted, the stopper’s pin should

rest inside the pad unit’s smaller hole. (See Figure 5.)

• If you were to play your pad unit without the stopper’s pin positioned fully inside the smaller

hole, it could slip out of the hole as you play.

8 For PCY155 and PCY135:

Place one of the felt pads removed in Step 2 on the cymbal holder. (See Figure 5.)

For PCY100:

Place the felt pad that came with your pad unit. The second felt pad removed from the cymbal

holder in Step 2 above is not required for assembly of your pad unit. (See Figure 5.)

9 Tighten the wing nut to secure the pad unit to the cymbal holder. (See Figure 5.)

The function of the PCY series pads varies according to which trigger input jack on the DTX Series

Drum Trigger Module the pad is connected.

Refer to the following website for its function in relation to trigger input jacks.

https://download.yamaha.com/

Pads & Trigger Input Jacks

Cymbal holder

Bolt cover

Wing nut

Felt Pad

Felt (Only for PCY100: The felt

pad that came with pad unit)

Stopper

[Figure 5]

Pad unit

Cup

Stopper’s pin

Smaller

hole