User Manual

Getting Started
English
2
Chapter
23
If your wireless router (access point) does not support WPS, you can connect
this product to a wireless router (access point) using an Ethernet cable.
1 Press the [P] (Standby/On) button to turn the power off.
Note:
2 Connect the wireless router (access point) to the [LAN] port
on the control center unit using an Ethernet cable.
Note:
For details on the DHCP setting, refer
to the owner’s manual supplied with
your wireless router (access point).
3 Enable the DHCP server function on the wireless router
(access point).
4 Press the [P] (Standby/On) button to turn the power on.
Connection between this product and the wireless router (access point)
is automatically established in approximately 15 to 20 seconds.
Note:
For details on the Wi-Fi setting,
refer to the owner’s manual supplied
with your smart device.
5 Open the Wi-Fi setting screen on your smart device.
6 Enable the Wi-Fi function.
7 From the displayed network list, tap the network to which
this product is connected.
If necessary, enter a password, and then connect.
Wired Network Connection
To ensure proper security, when
connecting this product to the
Internet, be sure to connect via a
router, etc.
Set an appropriate password for the
router, etc. being used.
Do not connect directly to the
communication circuits (including
public line LAN) of the
telecommunications carriers (mobile
telecommunication companies,
fixed-line telecommunication
companies, Internet providers, etc.).
Wireless router
(access point)
Ethernet cable
Control center unit