Owner's Manual

PREPARATIONS Placing speakers En 12
Select the speaker layout for the number of speakers that you are using and place the speakers and subwoofer (with built-in amplifier) in your room. This section describes the
representative speaker layout examples.
* HTR-5065 only
HTR-5065 supports 2- to 7.1-channel system, and HTR-4065 supports 2- to 5.1-channel speaker system.
1 Placing speakers
Caution
(U.S.A. model only)
Under its default settings, the unit is configured for 8-ohm speakers. When connecting 6-ohm speakers, set the unit’s speaker impedance to “6 Ω MIN”. In this case, you can also use 4-ohm speakers as the front speakers.
For details, see “Setting the speaker impedance” (p.14).
(Except for U.S.A. model)
Use speakers with an impedance of at least 6 Ω.
Speaker type Abbr. Function
Speaker system (the number of channels)
7.1* 6.1* 5.1 4.1 3.1 2.1
Front (L) 1
Produce front right/left channel sounds (stereo sounds).
●●●●●●
Front (R) 2 ●●●●●●
Center 3 Produces center channel sounds (such as movie dialogue and vocals). ●●●
Surround (L) 4
Produce surround right/left channel sounds.
●●●●
Surround (R) 5 ●●●●
Surround back (L)* 6
Produce surround back left/right channel sounds.
Surround back (R)* 7
Surround back* 8 Produces sounds mixed from surround back left/right channel sounds.
Subwoofer 9
Produces LFE (low-frequency effect) channel sounds and reinforces the bass parts of other channels.
This channel is counted as “0.1”.
●●●●●●
1
Speaker placement
2 3 4 5 6 7 8 9 10