Owner's Manual

En 16
■ Connecting speaker cables
Each speaker has two speaker cables. One is for
connecting the - (negative) terminal of the unit and the
speaker, and the other is for the + (positive) terminal.
The cables are different colors, so they do not get mixed
up. Connect the black side to the - (negative) terminal
and the other side to the + (positive) terminal.
1 Remove approximately 10 mm (0.4 in.) of insulation
from the end of the speaker cable and twist the bare
wire firmly.
2 Loosen the speaker
terminal.
3 Insert the bare wire
into the gap on the
side of terminal.
When it is difficult to
insert the wire into the
gap on the side,
insert it into the gap downside of terminal.
4 Tighten the terminal.
Connecting with a banana plug (Except for U.K.,
Europe, Asia and Korea models)
Tighten the knob, and then insert a banana plug into the
end of the terminal.
■ Connecting a subwoofer
Use monaural pin cable to connect a subwoofer.
Before connecting a subwoofer, turn off the subwoofer.
Connecting front speakers
compatible with bi-amp
connection
When you use front speakers that support bi-amp
connection, connect the speakers to FRONT terminals
and SURROUND BACK/ BI-AMP terminals.
To activate the bi-amplification connections, set the “BI-
AMP” (p.77) to “ON” in the “ADVANCED SETUP” menu
after connecting the power plug.
F
R
O
N
T
+ (Red)
- (Black)
F
R
ON
T
Banana plug
Monaural pin cable
FRONT CENTER SURROUND
SINGLE
SUBWOOFER
RL R RLL
SURROUND BACK/
BI-AMP
SPEAKERS
The unit (rear)
NOTES
• Before making the bi-amplification connections, remove any
brackets or cables that connect a woofer with a tweeter. When
not making bi-amplification connections, make sure that the
brackets or cables are connected before connecting the speaker
cables. Refer to the instruction manual of the speakers for more
detail.
• When making the bi-amplification connections, the surround
back speakers are not available.
1 2
Connecting speakers
3 4 5 6 7 8