Owner`s manual
Table Of Contents
- INTRODUCTION
- PREPARATION
- Connections
- Rear panel
- Placing speakers
- Connecting speakers
- Setting the speaker impedance
- Information on jacks and cable plugs
- Information on HDMI™
- Connecting video components
- Connecting audio components
- Using the VIDEO AUX jacks on the front panel
- Connecting the FM and AM antennas
- Connecting the power cable
- Turning on and off the power
- Front panel display
- Optimizing the speaker setting for your listening room
- Connections
- BASIC OPERATION
- ADVANCED OPERATION
- ADDITIONAL INFORMATION
- APPENDIX
- Control Diagram
15 En
Connections
English
PREPARATION
You can play back pictures by connecting your video monitor and video source component to this unit using HDMI
connections.
At that time, audio/video signals output from the connected component (such as DVD player etc.) are output to the
connected video monitor only when this unit is turned on and set to the input source (
DVD or DTV/CBL).
Furthermore, available audio/video signals depend on the specification of the connected video monitor. Refer to the
instruction manual of each connected component.
■ HDMI jack and cable plug
y
• We recommend using an HDMI cable shorter than 5 meters
(16 feet) with the HDMI logo printed on it.
• Use a conversion cable (HDMI jack
↔ DVI-D jack) to connect
this unit to other DVI components.
Information on HDMI™
Audio signals input at the HDMI jack are not output from any speaker terminals but output from the connected video
monitor.
To enjoy the sound from speakers connected to this unit,
– make an analog or digital connection besides the HDMI connection (see page 16).
– mute the volume of the connected video monitor.
HDMI cable plug
HDMI