Owner`s manual
Table Of Contents
- INTRODUCTION
- PREPARATION
- Connections
- Rear panel
- Placing speakers
- Connecting speakers
- Setting the speaker impedance
- Information on jacks and cable plugs
- Information on HDMI™
- Connecting video components
- Connecting audio components
- Using the VIDEO AUX jacks on the front panel
- Connecting the FM and AM antennas
- Connecting the power cable
- Turning on and off the power
- Front panel display
- Optimizing the speaker setting for your listening room
- Connections
- BASIC OPERATION
- ADVANCED OPERATION
- ADDITIONAL INFORMATION
- APPENDIX
- Control Diagram
26 En
Optimizing the speaker setting for your listening room
6 Press
G
ENTER to display the setup results
in detail.
7 Press
G
l / h repeatedly to toggle between
the setup result displays.
y
If you are not satisfied with the results or want to manually
adjust each parameter, run “MANUAL SETUP” (see
page 46).
The distances displayed in the “DISTANCE” results may be
longer than the actual distance depending on the
characteristics of your speakers.
8 Press
G
ENTER to return to the
“AUTO:RESULT” display.
9 Make sure the pointer is pointing at “SET”
and “CANCEL” and then press
G
l / h to
select “SET” or “CANCEL”.
Choices: SET, CANCEL
• Select “SET” to confirm the “AUTO SETUP”
results.
• Select “CANCEL” to cancel the “AUTO SETUP”
results.
10 Press
G
ENTER to confirm your selection.
The top “SET MENU” display appears in the OSD.
11 Press
Q
MENU to exit from “SET MENU”.
12 Disconnect the optimizer microphone from
this unit.
The optimizer microphone is sensitive to heat. Keep it
away from direct sunlight and do not place it on top
of this unit.
y
If you change speakers, speaker positions, or the layout of
your listening environment, run “AUTO SETUP” again to
recalibrate your system.
Note
Results of the speaker
connection and wiring
Results of the speaker
distance from the
listening position
Results of the speaker
size
Results of the speaker
output level
AUTO:RESULT
NO WARNING
RESULT
SP : 3/2/0.1
DIST: 3.2/3.5m
LVL : -2/+2dB
. SET CANCEL
[ ]/[ ]:Up/Down
[ENTER]:Enter
>
SET MENU
TOP MENU
.;AUTO SETUP
;MANUAL SETUP
.A;SIGNAL INFO
[ ]/[ ]:Up/Down
[ENTER]:Enter
p
p