Owner’s Manual

En 103
Setup menu items
Menu Item Function Page
Speaker
Auto Setup Automatically optimizes the speaker settings (YPAO). 36
Manual Setup
Power Amp Assign Selects a speaker system. 105
Configuration
Front Selects the size of the front speakers. 105
Center Selects whether or not a center speaker is connected and its size. 105
Surround Selects whether or not surround speakers are connected and their size. 105
Surround Back Selects whether or not surround back speakers are connected and their size. 106
Front Presence Selects whether or not presence speakers are connected. 106
Subwoofer Selects whether or not a subwoofer is connected and its phase. 106
Layout Selects a surround speaker layout when surround speakers are used. 106
Bass Cross Over Sets the lower limit of the low-frequency component that can be output from speakers whose size is set to “Small”. 106
Distance Sets the distance between each speaker and listening position. 107
Level Adjusts the volume of each speaker. 107
Parametric EQ Adjusts the tone with an equalizer. 107
Test Tone Enables/disables the test tone output. 108
Sound
Lipsync
Delay Enable Enables/disables the Lipsync adjustment for each input source. 108
Auto/Manual Select Selects the method to adjust the delay between video and audio output. 108
Adjustment Adjusts the delay between video and audio output manually. 109
Dynamic Range Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and DTS signals) playback. 109
Max Volume Sets the maximum volume to prevent excessive loudness. 109
Initial Volume Sets the initial volume for when this receiver is turned on. 109
Adaptive DSP Level Selects whether to automatically adjust the CINEMA DSP effect level when the volume is adjusted. 109
CINEMA DSP 3D Mode Enables/disables CINEMA DSP 3D. 109
Virtual Surround Back Speaker Selects whether to create Virtual Surround Back Speaker (VSBS) using the surround speakers. 109
Video Video Mode Enables/disables the video signal processing (resolution and aspect ratio). 110
HDMI
HDMI Control Enables/disables HDMI Control. You can also configure the relevant settings (such as ARC and TV audio input). 111
Audio Output Selects a device to output audio. 112
Standby Through Select whether to output videos/audio (input through HDMI jacks) to the TV when the unit is in standby mode. 112