Owner's Manual

21 En
Optimizing the speaker setting for your listening room (YPAO)
English
INTRODUCTION
ADDITIONAL
INFORMATION APPENDIX
PREPARATION
BASIC
OPERATION
ADVANCED
OPERATION
Press oCursor n once, and select “Retry” or
“Exit” using oCursor l / h and then press
oENTER.
Retry
Performs “Auto Setup” again.
Exit
Terminates the measurement and “Auto Setup.”
y
• See page 69 for details on error messages.
• When “E-5:NOISY” appears, you can continue measurement. To
continue measurement, select “Proceed.” However, we recommend that
you solve the problem first and then perform measurement again.
If a problem occurs during measurement, “WARNING” is
displayed on the result display screen. Check the error and
solve the problems.
y
• See page 70 for details on warning messages.
• Optimization will not be performed while a warning message is
displayed. We recommend that you solve the problem and perform “Auto
Setup” again.
1 Check if “→” is displayed on the left of
“WARNING” and press oENTER.
Details of the warning message are displayed. If there
are multiple warning messages, you can display the
next message using oCursor h.
2 To return to the top result display, press
oENTER again.
When an error message is displayed
during measurement
ERROR
Don't

operate
.E-9:USER CANCEL
[ENTER]:Return
any function
>RetryExit
[]/[]:Select
p[
When a warning message is displayed
after measurement
WARNING
Reversechannel
W-1:OUTOFPHASE
[ENTER]:Return
FL---
CENTER
SL---

SBL---
[]/[]:Select
p[