Owner's Manual

65 En
Troubleshooting
English
INTRODUCTION
APPENDIX
PREPARATION
BASIC
OPERATION
ADVANCED
OPERATION
If an operation takes longer than usual or an error occurs, one of the following messages may appear on the front panel
display. In this case, read the cause and follow the corresponding remedies.
AM
The desired station
cannot be tuned into
with the automatic
tuning method.
The signal is weak or the antenna
connections are loose.
Adjust the AM loop antenna orientation. 18
Use the manual tuning method. 29
There are continuous
crackling and hissing
noises.
Supplied AM loop antenna is not
connected.
Connect the AM loop antenna correctly even
if you use an outdoor antenna.
18
The noises may be caused by lightning,
fluorescent lamps, motors, thermostats
and other electrical equipment.
It is difficult to completely eliminate noise,
but it can be reduced by installing and
properly grounding an outdoor AM antenna.
18
There are buzzing and
whining noises.
A TV set is being used nearby. Move this unit away from the TV set. —
XM Satellite Radio (U.S.A. model only)
Problem Cause Remedy
See
page
Status message Cause Remedy
See
page
CHECK XM TUNER The XM Mini-Tuner is not installed in the
XM Mini-Tuner Home Dock or the XM
Mini-Tuner Home Dock is not connected
to this unit.
Confirm the XM Mini-Tuner is fully seated in the
dock and check the XM Mini-Tuner Home Dock
cable is connected to this unit.
31
CHECK ANTENNA The XM antenna is not connected to the
XM Mini-Tuner Home Dock or the XM
antenna cable has become damaged.
Check that the XM antenna is securely connected to
the XM Mini-Tuner Home Dock and check the
antenna cable for damage. Replace the XM antenna if
the cable is damaged.
31
LOADING XM The XM Mini-Tuner is acquiring audio or
program information from the XM
satellite signal. This message can also
occur in weak XM signal conditions. Note
that this unit may not respond to some
operations while this message is
displayed.
This message should disappear in a few seconds in
good signal conditions. If you see this message often,
reposition the XM antenna to get better signal
reception. Use the “ANTENNA INFO” information
on the front panel display or “XM Information”
screen in the video monitor to check the antenna
reception level.
34
NO SIGNAL The XM Mini-Tuner is not receiving the
XM satellite signal. Something may be
blocking the XM antenna’s view of the
satellites or the antenna is not properly
aimed.
Check for antenna obstructions and reposition the
XM antenna to get better signal reception. Use the
“ANTENNA INFO” information on the front panel
display or “XM Information” screen in the video
monitor to check the antenna reception level. See
instructions supplied with the XM Mini-Tuner and
Dock for antenna installation information.
34
CH OFF AIR The XM channel you selected is not
currently broadcasting.
Check back at a later time; in the meantime, select
another channel.
—
CH UNAUTH You may be attempting to tune to an XM
channel that is blocked or that you cannot
receive with your XM subscription
package.
Consult the latest channel guide at
http://www.xmradio.com/ for the current list of
channels. For information on receiving this channel,
visit http://www.xmradio.com/ or contact XM
Satellite Radio at 1-800-967-2346.
31