Owner's Manual
Table Of Contents
- HTR-6260 Owner's Manual
- English
- INTRODUCTION
- PREPARATION
- Preparing remote control
- Connections
- Placing speakers
- Connecting speakers
- Information on jacks and cable plugs
- Connecting a TV monitor or projector
- Connecting other components
- Connecting an external amplifier
- Using REMOTE IN/OUT jacks
- Connecting a Yamaha iPod universal dock or Bluetooth™ wireless audio receiver
- Using the VIDEO AUX jacks on the front panel
- Connecting the FM and AM antennas
- Connecting the power cable
- Turning this unit on and off
- Optimizing the speaker setting for your listening room (YPAO)
- BASIC OPERATION
- ADVANCED OPERATION
- APPENDIX
- List of remote control codes
- English
- HTR-6260 Controls Diagram
![](/manual/yamaha/htr-6260/owner-s-manual-english-malay-macrolanguage/images/img-69.png)
66 En
Troubleshooting
If an operation takes longer than usual or an error occurs, one of the following messages may appear on the front panel
display. In this case, read the cause and follow the corresponding remedies.
CH UNAVAIL The selected channel is not available. The
channel may have been reassigned to a
different channel number. This message
may occur initially with a new XM Mini-
Tuner or an XM Mini-Tuner that has not
received XM’s signal for an extended
period.
Consult the latest channel guide at
http://www.xmradio.com/ for the current list of
channels. For cases of a new XM Mini-Tuner or an
XM Mini-Tuner that has not received XM’s signal for
an extended period, allow the XM Mini-Tuner to
receive the XM satellite signal for at least 5 minutes
and then try to select the channel again.
—
UPGRADE XM TUNER This unit has detected a XM CNP1000
which is not compatible with this unit.
If you have connected the XM Mini-Tuner
(CNP2000) and see this message, set this unit to
standby, disconnect and reconnect the XM Mini-
Tuner Home Dock and re-install the Mini-Tuner in
the Home Dock and turn on this unit.
If you continue to see this message with the XM
Mini-Tuner, contact XM Satellite Radio at
http://xmradio.com/ or 1-800-XMRADIO (1-800-
967-2346).
If you have an incompatible XM CNP1000, contact
XM for information on upgrading to the XM Mini-
Tuner.
—
- - - - No artist name or song title is available for
this selection.
No action required. —
SIRIUS Satellite Radio (U.S.A. model only)
Status message Cause Remedy
See
page
ANTENNA ERROR The antenna is not connected to the
SiriusConnect tuner properly.
Check the connection of the antenna and
SiriusConnect tuner.
35
SIRIUS LOADING This unit is communicating with the
SiriusConnect tuner.
The message disappears normally within several tens
of seconds.
—
CHECK SR TUNER The SiriusConnect tuner is not connected
to the SIRIUS jack of this unit correctly.
Check the connection of the SiriusConnect tuner and
this unit.
35
The SiriusConnect tuner is not connected
to the AC wall outlet.
Connect the power cable of the SiriusConnect tuner to
the AC wall outlet.
35
NOT SUPPORTED This unit does not support the connected
SIRIUS Satellite Radio tuner.
Connect the SiriusConnect tuner that this unit
supports,
35
ACQUIRING The signal is too weak. Adjust the orientation of the antenna of the
SiriusConnect tuner. Use the “Antenna” information
on the front panel display or “SIRIUS Information”
screen in the video monitor to check the antenna
reception level.
39
UPDATING The SiriusConnect tuner is updating the
channel list.
Wait until the updating is complete. —
The period of the subscription is end. Contact SIRIUS Satellite Radio to renew the
subscription.
35
F/W UPDATING The SiriusConnect tuner is updating the
firmware.
Wait until the updating is complete. —
Status message Cause Remedy
See
page