Owner's Manual

64 En
Troubleshooting
No sound is output
from a specific
speaker.
Output from that speaker is disabled. Check the Speaker indicators on the front panel
display. If the corresponding indicator is turned off,
try the following.
1) Change the input source to another one.
2) With the selected sound field program, sound is not
output from that speaker. Select another sound field
program.
3) “None” may have been selected for that speaker on
this unit. Display “Speaker Setup” in the “Setup”
menu and enables output of that speaker.
6, 24, 27,
46
The volume of that speaker is set to
minimum in “Speaker Setup” in the
“Setup” menu.
Display “Speaker Setup” in the “Setup” menu and
adjust the volume (Manual Setup → Speaker Level).
48
This unit is in the straight decode mode. Press QSTRAIGHT (or rSTRAIGHT) to turn
off the straight decode mode.
30
Sound may not be output from certain
channels depending on input sources or
sound field programs.
Try another sound field program. 27
The speaker is malfunction. Check the speaker indicators on the front panel
display. If the corresponding indicator lights up,
connect another speaker and check if sound is output.
If sound is not output, this unit may be malfunction.
—
No sound is heard
from the subwoofer.
“LFE / Bass Out” is set to “Front” and a
Dolby Digital, DTS or AAC signals is
being played.
Set “LFE / Bass Out” to “Subwoofer” or “Both”. 47
“LFE / Bass Out” is set to “Subwoofer” or
“Front” and a 2-channel source is being
played.
Set “LFE / Bass Out” to “Both”. 47
The source does not contain low
frequency signals.
No sound is heard
from the surround
back speakers.
“Extended Surround” in the Option menu
is set to “Off”, or an input signal does not
contain a surround back flag with
“Extended Surround” set to “Auto”.
Set “Extended Surround” other than “Off” or “Auto”. 41
The audio input
sources cannot be
played in the desired
digital audio signal
format.
The connected component is not set to
output the desired digital audio signals.
Set the playback component properly referring to its
operating instructions.
—
Multi-channel
playback is not
available.
The connected component is set to output
2-ch or PCM signals.
Set the playback component properly referring to its
operating instructions.
—
“Audio Output” is set to “Amplifier +
TV”.
Set “Audio Output” to “Amplifier”. 49
Problem Cause Remedy
See
page