Owner's Manual
CONFIGURATIONS ➤ Configuring the system settings (ADVANCED SETUP menu) En 105
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press MAIN ZONE
z
.
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE z to set the unit to standby mode and turn it on
again.
The new settings take effect.
ADVANCED SETUP menu items
Changing the speaker impedance setting (SP IMP.)
Change the unit’s speaker impedance settings depending on the impedance of the
speakers connected.
Settings
Configuring the system settings
(ADVANCED SETUP menu)
MAIN ZONE z
STRAIGHTPROGRAM
Item Function Page
SP IMP. Changes the speaker impedance setting. 105
REMOTE ID Selects the unit’s remote control ID. 106
TV FORMAT Switches the video signal type. 106
MON.CHK Removes the limitation on HDMI video output. 106
INIT Restores the default settings. 106
UPDATE Updates the firmware. 107
VERSION Checks the version of firmware currently installed on the unit. 107
6 Ω MIN
Select this option when you connect 6-ohm speakers to the unit. You
can also use 4-ohm speakers as the front speakers.
8 Ω MIN (default)
Select this option when you connect 8-ohm or higher speakers to the
unit.
SPIMP.8MIN