Installation manual

ManualsBrandsYamaha ManualsOtherHTR3071

RX-V383/HTR-3071

IMPORTANT NOTICE

Do not attempt to update your Yamaha receiver using any other data file except which provided directly from the

Yamaha website.

Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by

Yamaha.

Improperly updated products may cause improper operation, and any parts or service required to restore proper

operation will not be covered under the Yamaha Limited Warranty.

FIRMWARE UPDATING PROCEDURE

Click here for

Firmware Update by USB

(A USB thumb drive is required)

In case of error, see the

Troubleshooting

section

Summary of content (4 pages)

PAGE 1
RX-V383/HTR-3071 FIRMWARE UPDATING PROCEDURE IMPORTANT NOTICE Do not attempt to update your Yamaha receiver using any other data file except which provided directly from the Yamaha website. Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by Yamaha. Improperly updated products may cause improper operation, and any parts or service required to restore proper operation will not be covered under the Yamaha Limited Warranty.
PAGE 2
RX-V383/HTR-3071 Firmware Update by USB Requirement: USB thumb drive, with enough free space to store over 25MB. (File system with FAT16 or FAT32 format) Firmware file provided by YAMAHA, “R0xxx-xxxx.bin”. 1 Prepare USB thumb drive for the update Download the firmware, unzip and copy “R0xxx-xxxx.bin” into the root directory of the USB thumb drive. Drag & Drop the file into USB thumb drive. R0xxx-xxxx.
PAGE 3
RX-V383/HTR-3071 6 Start firmware update a. Press INFO key to start the update. (Update process may take up to 10 minutes) * If “ UPDATE SUCCESS ” appears, this means your receiver is already up-to-date. In this case, power off to exit from Advanced Setup. Your AV receiver is ready for normal use. Firmware update in progress Caution DO NOT interrupt power during the update.
PAGE 4
RX-V383/HTR-3071 Troubleshooting CASE 1 Error message appeared during the update Cause: For some reason, the receiver can’t read the firmware data. Method: For your solution, check the following [Update by USB thumb drive] ❏ USB thumb drive is connected properly to the receiver. ❏ USB thumb drive is not password protected. (AV receiver cannot read data from a security protected USB thumb drive) ❏ Make sure the USB thumb drive is inserted before the receiver is powered on for the update.