User Guide
Optional Boards
for
DSP UNIT
T
hank you for choosing the board for Yamaha DSP1D (DSP unit).
Ask an authorized Yamaha service engineer to install the board. Do not install the board yourself.
ここ
の度はヤマハ DSPユニットDSP1D用ボードを お 買 上 げ い た だき、あり がとうござ います 。
ボードの取付けは、必ずヤマハサービスエンジニアにご依頼ください。お客様ご自身では行なわないでください。
The following items are optional boards available for the DSP1D.
DSP1D用にオプションでお求めいただけるボードは 次 のとおりで す。
INPUT DSP BOARD インプット DSPボード IDB1D
CONSOLE INTERFACE BOARD コンソールインタフェースボ ード CIB1D
ENGINE MANAGEMENT BOARD エンジンマネージメントボ ード EMB1D
PATCH DSP BOARD パッチ D S Pボード PDB1D
GROUP DSP BOARD グループDSPボード GDB1D
EFFECT DSP BOARD エフェクトDSPボード EDB1D
■ Installing the board (For only an authorized Yamaha service engineers)
ボード装着手順(ヤマハサービスエンジニア用)
Before installing the board, be sure to turn off the power to the DSP1D and disconnect the power cord.
You need to remove the front cover of the DSP1D to install any board. To install the PDB1D board, you also need to remove the
left side cover.
ボードの装着作業は必ずDSP1D の電源スイッチを切り、電源コードを抜いてから行なってください。
パッチDSPボード PDB1D以外のボードの装着はユニット正面のカバーを取りはずして行ないます。PDB1Dボードの装着はさらに ユ ニット
左側面カバーのとりはずしが必要です。
1. Remove ten screws as
shown in the picture. Do
not remove any other
screws. Keep the re-
moved screws in a safe
place since you will need
them to re-attach the
cover.
2. As shown in the picture,
remove the cover by
opening from the right
side to avoid damage to
the hardware on the left
side of the rack.
10ヶ所のネジをはずします。写
真に示した以外のネジははずさ
ないでください 。また取りは ずし
たネジは カバ ーを 再 び 取り付け
る際、必要ですので紛失しない
でください 。
正面カバー
front cover
左側ラック金具
hardware on the left side of the rack
左側ラック金具を破損しないよ
う写真のように正面カバーを右
側から先に開けて取りは ずしま
す。