User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
114
8.
Set the PGM1’s [UNIT ID] rotary switch and DIP switch.
If the device is not nearby, you can set it during the step “Connecting the equipment.”
Make the following settings.
9.
When you’ve finished setting the PGM1’s [UNIT ID] rotary switch and DIP switch, click
[Next>].
10.
Click [Next>].
For the MRX, use MRX Designer to select the Mini-YGDAI card.
PGM1
UNIT ID = 60
[UNIT ID] rotary switch =0
DIP switch = 2 and 3 are ON (downward), others are OFF (upward)