User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
131
5.
Drag and drop to connect “ANALOG IN” output ports 1 through 6 to each “Source
Selector” Src1-1 through Src3-2.
6.
Drag and drop to connect the WXC-50’s outputs to each “Source Selector” Src4-1 and
Src4-2.
7.
Drag and drop to connect between the ports from “HPF” to “PEQ.”
ANALOG IN 7 and 8 Studio A Src4-1 and Src4-2
STEREO IN 1L and 1R Studio B Src4-1 and Src4-2
STEREO IN 2L and 2R Spin Area Src4-1 and Src4-2