User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 3) A paging system using the PGM1
MRX Setup Manual
134
15.
Drag and drop to connect “YDIF IN” output ports 1 through 3 to the input port of each
User Defined Block.
16.
Select the area from “Fader(2)” through “Matrix Mixer(3),” so that the components are
selected.
17.
On the [Edit] menu, choose [Create User Defined Block]; in the dialog box, set IN as 3,
set OUT as 2, and click the [OK] button.
18.
As necessary, change the position, size, and arrangement of the components in the
User Defined Block.
YDIF IN 1 Input Ch Strip (Studio A)
YDIF IN 2 Input Ch Strip (Studio B)
YDIF IN 3 Input Ch Strip (Spin Area)