User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 2) Remote conferencing system that also uses Speech Privacy
MRX Setup Manual
91
4.
After clicking [Ch01:Level], hold down <Ctrl> and click [Ch02:Level].
You can select multiple items while holding down <Ctrl> and clicking.
To select continuous parameters, click the start parameter, hold down the <Shift> key and then click on the end
parameter.
5.
Do a right-click and select [Add to Parameter Link Group] → [Add New Group].
A dialog box for setting the parameter link group name will open.
6.
Input [Speaker Level] and click the [OK] button.
The [Speaker Level] group will be generated in the “Parameter Link Group” area, and the Link Master editor will
appear.
7.
Select [Absolute] on the Link Master editor combo box.