User Manual
Table Of Contents
- About Audinate
- Introduction
- Installing Dante Controller
- Dante Basics
- Starting Dante Controller
- Using Dante Controller
- Presets
- Troubleshooting
- Fanout
- Messages on Startup
- Computer Configuration Checklist
- Troubleshooting Dante IP Address Configuration
- Troubleshooting Switch Configuration and Cabling
- Index
Dante Controller User Guide
Copyright © 2014 Audinate Pty Ltd. All rights reserved.
-25-
Starting Dante Controller
Where to find the Dante Controller application
Windows
By default Dante Controller will be installed in
C:\Program Files\Audinate\Dante Controller\
It can be started in several ways:
n Using the Start menu: Start > Programs > Audinate > Dante Controller > Dante Controller
n Run by going to Start > Run and entering
C:\Program Files\Audinate\Dante Controller\DanteController.exe
in the dialog box
n
Navigate to the directory where it is installed, and double-click the Dante Controller icon:
Mac OSX
The Dante Controller application will be installed in the Applications folder.
To start:
n
Navigate to Applications folder, and double-click the Dante Controller icon:
Or:
n Drag the icon to the Dock and click on it
Configuring Dante Controller
Network Interface Selection
Dante Controller can communicate with other Dante devices on the primary network, or the secondary
network, or both. Dante Controller needs to know which of the network interfaces of the host computer is
connected to each Dante network.
The first time Dante Controller is run, you may be presented with the Configure Dante Interfaces dialog
box (shown below), providing a list of interfaces from which to select the primary and secondary Dante
interfaces. Once interfaces have been selected, they are remembered for future use, and this dialog box
will not be shown when Dante Controller is run subsequently.