User Manual

“Channel Select” dialog box Chapter 4. System screen
MTX-MRX Editor User Guide
124
❑ “Channel Select” dialog box
Here you can select the signals that are output from the MTX to YDIF.
If nothing is selected, the signal will not be output to YDIF.
For the MRX, the connection lines in the “MRX Designer” window determine the destination.
• [YDIF:] box
Select the YDIF channel that you want to edit.
•[Thru] button
The signals coming into YDIF input will be sent to the same YDIF channel without
change.
• INPUT CHANNEL (POST ON)
The input channel’s POST signal (after MUTE switching) will be sent to the YDIF
channel.
• STEREO INPUT CHANNEL (POST ON)
The stereo input channel’s POST signal (after MUTE switching) will be sent to the
YDIF channel.
• ZONE OUT
The signal of the zone output will be sent to the YDIF channel.
• OUTPUT CHANNEL
The signal of the output channel will be sent to the YDIF channel.
• [Close] button
Closes the “Channel Select” dialog box.