User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“XMV” screen Chapter 4. System screen
MTX-MRX Editor User Guide
137
5 XMV identification area
Shows the UNIT ID, model type, and model name of the corresponding XMV unit.
6 [POWER]
If you click the [STANDBY] button, the power of the corresponding XMV unit will be
switched to standby. If you click the [ON] button, the power of the corresponding XMV
unit will be switched on.
7 Input routing select buttons
These buttons open the “XMV Patch” dialog box where you can select the audio signal
output source device and channels.
To enable these buttons for a YDIF-connected or Dante-connected XMV unit, click the
[EDIT] button.
The color of the button’s edge changes to match what is specified for INPUT SOURCE
in the [Device] tab of the “Project” screen.
8 [LIMIT] indicator
This will light if the limiter of the XMV unit itself is operating.
9 Meter
Shows the output signal level.
0 Channel index
Indicates the channel number of the XMV.
A [MUTE] button
Switches mute on/off for the output channel.
B POLARITY button
Switches the polarity of the output signal.
C [PROTECTION] indicator
This will light if the protection function of the XMV unit itself is operating.
INPUT SOURCE Button edge color
YDIF Dark blue
Analog Ocher
DANTE Purple
5
7
8
9
6
<ABCED