User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Settings” dialog box Chapter 6. Presets
MTX-MRX Editor User Guide
152
•PLAY MODE
The [Play Mode] setting of the “SD Play” dialog box is shown.
[External Event]
Here you can specify an event to be output when a preset is recalled. An event is output
from the unit's NETWORK connector, or Dante [PRIMARY] or [SECONDARY]
connector, or the communication circuit during the redundancy operation.
If you specify an event for which [Event Mode] is set to [On/Off] in the “External
Events” dialog box, a command that is set to [On] will be output.
• [EVENT] list box
Select an event to be output.
• [OK] button
Saves the settings and closes the dialog box.
•[Cancel] button
Closes the dialog box without saving the changes.
■ “GPI Out” dialog box
Here you can specify the GPI OUT settings that will be output when the preset is recalled.
You can use GPI OUT output to control a device that’s connected to this unit’s [GPI OUT]
connector.
● [Active]/[Inactive]/[Ignore] buttons
Specify whether the GPI OUT connector’s output will be enabled (Active), enabled with
the OUTPUT TYPE inverted (Inactive), or ignored (Ignore).
If in the “Settings” dialog box accessed by the “System” menu command [GPI], the
[OUTPUT TYPE] setting is set to [Pulse] or [Pulse Inv.], the only available choices will
be [Active] and [Ignore].