User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
Recall Filter setting screen Chapter 6. Presets
MTX-MRX Editor User Guide
160
• [MATRIX SEND] button
If the button at the left is on, the following settings will be recalled.
• Send level from the input channel to the matrix bus, send on/off, and stereo channel
pan
• Send level from effect return to the matrix bus, send on/off, and stereo channel pan
If the button at the right is on, the matrix out level will be recalled.
• [ANC1 SEND]/[ANC2 SEND] buttons
If these buttons are on, the send level from the input channel to the ANC bus and
the send on/off status will be recalled.
•[ZONE] button
If this is on, the following settings will be recalled.
• 1st Priority’s Priority Source, Mix Level, and Ducker
• 2nd Priority’s Priority Source, Mix Level, and Ducker
•ANC
•Zone name
In the “MTX Configuration” dialog box, if [INPUT PORT SETUP] is changed from
“MONO x2” to “STEREO,” the setting of the [ZONE] button will follow the odd-
numbered zone.
• [PAGING] button
Turning this on recalls the setting of the PAGING [ON] button.
• [ZONE OUT] button
If this is on, the ZONE Out Level and on/off (mute) will be recalled.
• [DCA] button (ZONE side)
If this is on, the following settings will be recalled.
• ZONE Out’s channel assignment to DCA or mute group
• Master level of the DCA group
• Master mute of the mute group
• [ROUTER] button
If this is on, the router settings will be recalled.
NOTE