User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
Recall Filter setting screen Chapter 6. Presets
MTX-MRX Editor User Guide
161
• [LEVEL]/[OUTPUT] buttons
If the [LEVEL] button is on, the output channel level and on/off (mute) settings will
be recalled.
If the [OUTPUT] button is on, the Room EQ, Delay, and Speaker Processor settings
will be recalled.
These can be specified individually for each channel.
• [OUT PATCH] button
If this is on, the output patch settings and output channel names will be recalled.
• [OUT PORT] button
If this is on, the output port’s output gain and polarity settings will be recalled.
• [EXT. I/O YDIF] button
If this is on, settings for the audio that is output from the MTX/MRX to YDIF when
in Distribution mode will be recalled.
• [DCP] button
If this is on, the parameter assignments of the DCP (digital control panel) unit
connected to the MTX/MRX will be recalled. The button shows the ID of the DCP.
• [Wireless DCP] button
If this is on, the settings of the Wireless DCP will be recalled. If eight Wireless DCP
units are connected, eight units will be affected by the on/off setting.
•[MY4-AEC] button
If this is on, the settings of the MY4-AEC installed in the MTX5-D will be recalled.
This is not shown if the MY4-AEC is not selected in the “Device Configuration
Wizard.”
The following settings are outside the recall settings of the [MY4-AEC] button.
• From Far-end, Far-end Voice, Near-end Mic., Near-end Voice, and To Far-end
(included in the [IN PATCH] button range)
•SRC