User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“IP Address” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
171
9. In the “Device Information” dialog box, click the [Refresh] button.
Verify that the device’s IP address has been changed.
If you want to change the setting of multiple devices, repeat steps 3 through 5, and then
proceed to step 6 and following.
● Device list
Shows the devices on the network. When you click this, the settings of the current
device are shown in the right, allowing you to edit them.
● Current Settings
Shows the UNIT ID and IP Setting that are specified for the unit.
● Unit ID/Static IP(Auto)
If the unit’s IP Setting is “UNIT ID” or “STATIC IP (Auto),” the IP address and subnet
mask are shown.
● PC/Static IP(Manual)
❍ [DHCP] option button (MTX/MRX system devices only)
Choose this if you want the DHCP server to set the IP address.
If there is no DHCP server, the IP address will be set to [0.0.0.0]. To solve this
problem, check that the DHCP server is connected. Alternatively, use the rear panel
DIP switches of the unit to set IP Setting to [UNIT ID] (the mode in which the IP
address will be generated from the UNIT ID].
❍ [Apply to all the devices] button (MTX/MRX system devices only)
Sets all devices shown in the device list to DHCP mode.
❍ [Use the following IP Address] option button (MTX/MRX system devices only)
If you choose this, the IP address and subnet mask specified here will be used.
❍ IP Address/Subnet Mask
Here you can specify the device’s IP address and subnet mask.
Set the IP address so that it does not conflict with the IP address of the computer or
of any other device.
The following IP addresses cannot be specified.
192.168.0.0 - Use is prohibited because it conflicts with the network address
192.168.0.255 - Use is prohibited because it conflicts with the broadcast address
HINT
NOTE