User Manual

“Dante Information” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
180
❑ “Dante Information” dialog box
This shows Dante-related settings for Dante units such as the MTX5-D or XMV8280-D.
● [Preserve the Dante settings configured by Dante Controller]
check box
Select this check box if you’re using Audinate Corporation’s Dante Controller to set up
the Dante network. The settings of Dante Controller will take priority over the settings
made in MTX-MRX Editor. If this check box is cleared, you’ll be able to use MTX-MRX
Editor to make Dante network settings within the project.
● [Device Lock]
If the unit is set to Device Lock by Dante Controller, a lock icon is shown, and the unit
is excluded from editing.
● [AES67]
This indicates “Enabled” if the device is in AES67 mode.
● [UNIT ID]
Indicates the UNIT ID of the device.
● [Type]
Indicates the model name of the device.
● [Device Name]
Shows the device name. This name can be edited in DEVICE NAME, which is located
in the [Device] tab at the bottom of the Project screen.
● [Dante(A) S/W]/[Dante(A) F/W]/[Dante(Y) S/W]
Shows the version of the Dante firmware.
● [Secondary Port]
Shows the [SECONDARY PORT] settings of the DIP switch.
● [Bit]
Indicates the bit rate. The setting can be changed when offline.
● [Latency (ms)]
Indicates the latency in millisecond units. The setting can be changed when offline.
● [Primary Link Speed]/[Secondary Link Speed]
Indicates the communication speed settings of the Dante ports. If no other device is
connected to a port, or if the cable is broken, this will indicate “Link Down.”
● [Close] button
Closes the dialog box.