User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Daylight Saving Time” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
185
❑ “Daylight Saving Time” dialog box
This specifies the daylight saving time setting of the MTX/MRX devices connected to the same
network, regardless of their online/offline state.
• Events that are assigned within two hours before or after the beginning or end of daylight
saving time in the “Scheduler” dialog box will not be executed correctly.
• When you create a new project, the daylight saving time setting from the computer’s “Date
and Time” settings will be automatically shown in this dialog box.
● Unit ID
Indicates the UNIT ID.
● Type
Indicates the type of device.
● Device Name
Indicates the device name.
● DST
This indicates On if daylight saving time is specified for the device; it indicates Off if
daylight saving time is not specified.
● Offset
Indicates the amount of time by which the device’s daylight saving time is earlier than
standard time.
● Start Time
Indicates the time at which daylight saving time starts for the device.
● End Time
Indicates the time at which daylight saving time ends for the device.
NOTE