User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Scheduler” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
196
● [No Assign] option button
If this is selected, no broadcast is made when the event occurs.
● [Play] option button
If this is selected, a broadcast is made when the event occurs.
● SD CARD:/
This indicates the selected message file.
● [Browse] button
When you click this, a screen will appear, allowing you to select a message file.
● [Zone]/[Zone Group]
These specify the Zone(s) and Zone Group(s) to which the broadcast is made. Click
each square to turn it on (green) or off (white).
● [All On]/[All Off] buttons
Clicking these buttons turns all Zones or Zone Groups on or off.
● [OK] button
Click this to save the settings and close the dialog box.
● [Cancel] button
Click this to close the dialog box without saving the settings.