User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“External Events” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
198
❑ “External Events” dialog box
Here you can make settings for a command that will be transmitted to the network to which the
Dante connector or NETWORK connector is connected. This command can be triggered by
recalling a preset on the MTX/MRX; or by input from GIP IN; or by operation of an external device
such as a DCP unit.
Only commands are transmitted, and any reply to the commands will be discarded.
You can set up to 20 events per device. You can set up to 5 commands per event.
● [Device] list box
Select the MTX/MRX that will send commands. The list box shows units in order of the
UNIT ID and the name of the MTX/MRX.
● Menu button ( )
Click this button to execute the following functions.
• [Copy Event]
Copies the contents of the selected event to the copy buffer.
• [Copy All Event]
Copies the contents of all events to the copy buffer.
• [Paste Event]
Overwrites the event settings in the copy buffer.
• [Clear Event]
Initializes the contents of the selected event.
• [Clear All Event]
Initializes the contents of all events.
● [Event No.] list box
Specify the event number.
NOTE